Introduction To Auto desk AutoCAD | DAY 15

Follow by Email
Facebook
Facebook
Google+
Google+
http://graphic-world.co/3dgwg/learning/introduction-to-auto-desk-autocad-day-15/
RSS
Youtube
Youtube
Pinterest
Pinterest
LinkedIn
INSTAGRAM
SHARE

Learn AutoCAD basics: DAY 15

In this post, we are going to be perfecting how to handle positioning in AutoCAD.

The Object SNAP mode will be important for this session, The exercise itself is an easy one, but you need to be a bit cautious about where each of the object is placed in the project.

The use of the OFFSET command will be helpful and the ability to create a circle with the feature Tan, Tan, Radius.

LEARNING AUTOCAD BASICS

The following is the exercise we are going to be using in this session.

 

FIGURE 1

learn-AutoCAD

Additional important information are brought using the following image.

FIGURE 2

learn-AutoCAD

hey! If you have any confusion about this, Just leave a comment below. Let me know what is confusing about this, I will make it clear for you

EXECUTION

The following is the key image which will help complete this project.

learn-AutoCAD-Bacis

You need to first get the above image then Trim it, and you should get the following.

learn-AutoCAD-Bacis

What you need to do now is: Give the red part an OFFSET of 10 units, and you will end up with the following.

learn-AutoCAD-Bacis

It is all clear now, you surely know what to do next to complete today’s task. Do not forget the two FILLET of R5 we have just below the two circles.

Comments

comments

Follow by Email
Facebook
Facebook
Google+
Google+
http://graphic-world.co/3dgwg/learning/introduction-to-auto-desk-autocad-day-15/
RSS
Youtube
Youtube
Pinterest
Pinterest
LinkedIn
INSTAGRAM
SHARE